MODEL H8220
2" EXTENDED ANVIL
IMPACT WRENCH
INSTRUCTION SHEET
1
⁄
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection when
using this tool!
INJURY HAZARD!
Reverse Valve
Always disconnect tool from
air to prevent unexpected
operation during service!
Grease Fitting
DO NOT EXCEED 120 PSI!
Personal injury could
occur.
Figure 1. Model H8220
SHATTERING HAZARD!
Use sockets rated for
impact wrench use only.
Insert one shot of grease into the grease fitting
shown in Figure 1, every three months. The
impact wrench MUST be regularly lubricated with
3-4 drops of air tool oil directly into the air fitting
before each use. For best results, we recommend
using an in line filter, lubricator, and regulator, as
shown in Figure 2.
Specifications
Drive Size.........................................................1/2
"
No-Load Speed...................................7,500 RPM
Maximum Torque......................................420 ft/lb
Air Inlet Size..............................................1⁄4" NPT
Air Consumption.........................................5 CFM
Operating Pressure....................................90 PSI
Weight............................................................6 lbs
Quick
Connector
Quick
Connector
Lubricator
Regulator
Your
Tool
Air
Compressor
Inventory
1
Quick
Coupler
A.
B.
⁄
2" Extended Anvil Impact Wrench............. 1
4" NPT Air Fitting....................................... 1
1
⁄
Quick
Coupler
Air Hose
Filter
C. Oil................................................................1
Figure 2. Installing your tool.
Operation
1
Install any ⁄2" drive socket into your air impact
wrench. Push the reverse valve, shown in Figure
1, in or out to change direction. Turn the valve
knob from 1 to 6 to adjust air flow. Connect to air
line regulated at 90 PSI.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © AUGUST, 2007 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#JM9743 PRINTED IN CHINA
|